Innovate-motorsports LM-2 Manuel d'utilisateur Page 12
- Page / 50
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Document # 31-0008 LM2_Manual_1.3.doc
12
Do NOT install the Bung below the 3 o'clock or 9 o'clock position. Condensation
can form in the exhaust pipe and permanently damage the sensor. 6 o’clock is the
absolute worst position to mount the sensor.
Wide band oxygen sensors, like the one shipped with the LM-2, are designed to
work with unleaded gasoline. Use with leaded gasoline will significantly reduce the
lifespan of the sensor. The reduction is directly proportional to the metal content of the
fuel and the tune of the engine. In most cases, a wide band sensor will provide
accurate measurements somewhere between 50 hours and 500 hours with leaded fuel.
WHEN INSTALLED IN THE EXHAUST, THE OXYGEN SENSOR MUST BE
CONNECTED AND OPERATING WITH THE LM-2 WHENEVER THE CAR IS
RUNNING. AN UN-POWERED OXYGEN SENSOR WILL BE DAMAGED WHEN
EXPOSED TO EXHAUST GAS IF NOT PROPERLY POWERED.
The maximum temperature of the sensor at the bung (the sensor hexagon)
should not exceed 500
o
C or 900
o
F. If these temperatures are exceeded in your
application you should either install a double length bung (one inch) or the Innovate
Motorsports Heat-Sink Bung extender (HBX-1).
The double length bung is also recommended for situations where airflow is restricted.
It is NOT a good idea to do a sensor warm-up prior to starting the vehicle.
Depending on the climate and the sensor position in the exhaust, condensation can
form in the exhaust pipes. This condensation could then be blown by the exhaust
stream against the hot sensor when the car is started. The resulting heat shock can
permanently damage the sensor.
- Warning! 1
- 1.1 Main Screen 5
- 1.2 Status Bar 5
- 1.4 Recording 8
- 1.5 Playback 8
- 2 Air/Fuel Ratio Setup 10
- 2.2 Sensor Placement 11
- 2.3 Calibration Schedule 13
- 3.2 Updating Firmware 15
- 4 OBD-II 18
- 4.4 OBD-II Channel Speed 21
- 4.9 OBD II Basics 29
- 5 Analog Cable 31
- 5.2 Analog Inputs 33
- 5.3 Analog Outputs 34
- Advanced output programming 35
- Wiring Analog Outputs 36
- 6.1 Air/Fuel and Lambda 37
- 6.4 Single Cylinder Engines 38
- 6.5 Diesel Engines 38
- 6.6 Sensor Timing Errors 39
- Appendix A: Specifications 42
- Appendix B: Limited Warranty 43
- Appendix C: Connectors 44
- Appendix D: Supported PIDs 46
- Appendix F: Kit Contents 49
- 12. Revision History 50
Produits connexes et manuels pour Instruments de mesure Innovate-motorsports LM-2
(24 pages)Krohne Summit 8800 FR manuales
Manuales del propietario y guías del usuario para Equipo Krohne Summit 8800 FR.
Ofrecemos 1 manuales en pdf Krohne Summit 8800 FR para descargar gratis por tipos de documentos: Manual de usuario
Commentaires sur ces manuels