Innovate-motorsports MTX-D, Boost/Shift Gauge Manuel d'utilisateur télécharger pdf (Page 10)

- 10 -

5 Changing the MTX gauge face and/or bezel

1. Lay the MTX gauge face down and remove the three #2 phillips screws from the outside

rim of the back plate.

2. Carefully lift off the bezel from the gauge cup.

3. Configure the gauge as desired by changing the gauge face and or bezel.

*Be sure to remove protective film from the gauge face. This can be done easily

with a piece of scotch tape.

4. Make sure every piece is positioned correctly using the locating tab and reassemble the

gauge.

5. Reinstall the 3 #2 phillips screws.

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Innovate-motorsports MTX-D, Boost/Shift Gauge Manuel d'utilisateur Page 10