Innovate-motorsports LMA-3 Manuel d'utilisateur télécharger pdf (Page 21)

- 21 -

• Connect the ground from the external sensor supply to the GND connection on the LMA-

• Connect the +5V from the external sensor supply to the ‘+’ input of the channel to be

calibrated

• Press the Channel button until the channel number to be calibrated is displayed

• Press and hold the Calibrate button while the channel number is still displayed

The LMA-3 will either display a lower case ‘c’ to indicate the Calibration has occurred for the

selected channel or an upper case ‘E’ to indicate that the calibration could not occur. Normally

an E indicates that the voltage being input is .1V or more off from 5V.

10.1.3 Restoring a channel to factory calibration

In order to restore an external input back to the factory default calibration, the following steps

must be taken.

• Connect a jumper wire from the ‘+’ input of the channel to be restored to the GND

connection on the LMA-3

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Pas de commentaire

Innovate-motorsports LMA-3 Manuel d'utilisateur Page 21